A Single Source for Multiple Manufacturing Applications
All Categories > Water-Jet Cutting > Model # Katana2  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Model # Katana2, Water Jet Cutting


Sugino Machine: As a pioneer and a market leader in the Water Jet Technology Field, Sugino has developed a new abrasive mixing and energy saving Water Jet Cutting Machine. The new extra fine nozzle (minimum dia. 0.012 in. / 0.3mm) enables it to not only minimize cutting width, heat affection , and noise, but also reduces power and abrasive consumption. Thus lowering running costs and environmental burden.

Minimum dia. (0.012 in. / 0.3mm) cutting allowance was achieved with the development of the dia. (0.012 in./0.3mm) extra fine abrasive nozzle. Further precise cutting is enabled by harmonic combination of clean & stable Servo Jet Pump and high precise axis-control mechanism of machining center.This is the new generation Water Jet Cutting developed by our accumulated technical knowledge and many years of field experience.



Unit of Measure: Imperial Metric Both

Specifications  · Features

Specifications

Abrasive Nozzle Hole Diameter
0.012 - 0.020 Inch
0.3 - 0.5 mm

Stroke (X Axis)
9.8 Inch
240 mm

Stroke (Y Axis)
7.87 Inch
200 mm

Stroke (Z Axis)
7.87 Inch
200 mm

Discharge Pressure
43,600 psi
300 MPa

Max. Discharge Pressure
50,800 psi
350 MPa

Flow Rate
0.7 L/min
0.17 gpm

Rapid Feed Rate
20 m/min
66 ft/min

Machine Width
750 mm
30 Inch

Machine Length
2,050 mm
81 Inch

Machine Height
2,100 mm
83 Inch

Pump Width
27 Inch
685 mm

Pump Length
48 Inch
1,200 mm

Pump Height
61 Inch
1,530 mm

Power Supply (AC)
"AC200V Pump: 13k VA, Machine: 5k VA" V

Applications
  • Mechanical parts: High quality shape cutting or micro cutting for difficult to machine materials
  • Automobile and Aerospace: low-volume production of multiple varieties
  • Job Shop: New material cutting or trial tests
  • Sub

Applicable Material
CFRP
Copper
Laminated lumber
Paper
Polystyrene
Resin
Rubber
Stainless steel
Tempered Glass


Features

High Precision Material Cutting
Adopting an extra fine abrasive nozzle can achieve superior fine cutting and improvement of finished edge roughness as well as other typical features of water jet such as "no-heat affect" and "no-contact cutting". The Materials which are difficult for laser cutting, can also be handled.

Energy, Running Cost & Floor Space Savings
Uses 60%* less abrasives, which also contributed to the downsizing of the pump and reduction of running costs. The floor space of the machine only takes up 33 ft2 (3m2). *Depends on material thickness and material type.


 DOWNLOADS/VIDEOS 

Katana2_Waterjet_Cutting_Brochure
(PDF, 881KB)

Sugino_Water_Jet_Cutter_Cat_No_U3626NE
(PDF, 27738KB)