Request Information
Diamond tip type burnishing tool, CAT'S EYE can be applied to hard materials up to HRC 60. Throw-away tip enables quick and easy replacement.
  • For inner surface
Unit of Measure

Specifications

Processing Section

 N/A Inner Surface

Minimum Processing Diameter (in)

 N/A Ø0.787

Shank Diameter (in)

 N/A Ø0.984 Ø1

Maximum Processing Length (in)

 N/A 2.362

Surface Roughness (Ry µ inch)

 N/A Before burnishing ~ 4.0 (Rz), ~ 157 (Ry)

Work Piece Hardness (HRC)

 N/A 45 60

Peripheral Velocity (ft/min)

 N/A 165Ø650

Feed (in/rev)

 N/A 0.002

Spring Load (lbs)

 N/A 200 40

Tip Type and Number

 N/A DT2D1

Processing Conditions

N/A How to use

    1. Attach CAT'S EYE, do the turret of lathe.
    2. Set preload (spring tension built In the body).
    3. Rotate the work piece and feed the tool with correct processing parameters.
      Set tool pressing amount.
    • For outer and end surface: .004"-.012" in from the work piece surface.
    • For inner: .012-.021 in from the work piece surface.
    4.When tool reaches to the burnishing end point, stop the feed and separate the tool from the work piece to finish burnishing.
Note
  1. Tool rotation is not possible.
  2. Be sure to use lubricants while burnishing.
    Do not stop rotating the work piece until the tool is separated from it.
  3. One chuck processing is recommended from pre-burnishing to burnishing.
    One chuck processing = burnishing WITHOUT UNCHUCKING the work piece after pre-burnishing process.

Unprocessable Section by Superoll

N/A
Note
The above unprocessable length is values when the clearance between tool and processing end surface is .012 in.